1. XAUTH, which really is PSK + XAUTH
2. mutual group authentication, also known as hybrid
3. certificate based authentication
so, to be more specific on the cisco side, there are three types of
phase 1/1.5 that work with the cisco road warrior ``vpndialer''
program. You can tell which one your VPN is using by right-clicking
on its row in Connection Entries, picking Modify, and noting which of
the following three radio buttons is checked in the Authentication
tab:
Group Authentication -- this is pre-shared key + XAUTH, where any
roadwarrior VPN client has enough
passphrases loaded into it to impersonate
the head-end. The PSK is obfuscated in the
config file, but if you can un-rot13 it, you
can set up a spoof head-end and MITM nearby
wireless coworkers' passwords, not only
hijaaking your way into the VPN without a
password but probably also getting their
Master Windows Password to Everything, too,
thus imagineably making them LESS secure
than if they'd had no VPN at all.
Mutual Group Authentication -- This uses a certificate on the
head-end, but the road warrior
presents no certificate. Road
warriors validate the cert against a
CA certificate pubkey which you must
load into roadwarriors and use to
issue the head-end's cert, to stop
the MITM attack above. It seems to
be un-confusing, so a lot of sites
probably use it. It only works in
aggressive mode, though, because the
``client has no identity,'' or some
other weird IPsec standards-ism.
This is probably the 'hybrid' you are
talking about, also known as 'hybrid
XAUTH'. I understood once but am now
a bit rusty on how all Cisco's messy
configuration stanzas reference each
other, but have this in my notes (for
requesting it on PIX7.x/ASA head-end):
tunnel-group RoadWarrior ipsec-attributes
isakmp ikev1-user-authentication hybrid
Certificate Authentication -- This uses certificates on both clients
and servers, and can work in main mode
instead of aggressive mode. It's
possible to load a different cert into
each client and not use XAuth at all,
like in a site-to-site VPN. The VPN
dialer supports this, but almost
everyone uses XAuth.
But some shops load all their road
warriors with the same cert, same
private key, and then use XAuth to
distinguish one client from another.
Sometimes the VPN client .zip with the
client cert, private key and all, is
available for download on some open
external web page. Even with the
common client cert so freely
distributed, this behaves the same as
Mutual Group Authentication. It's
older, and it's probably better than
mutual group auth / hybrid xauth.
upside: works in Main Mode, not as
cisco-proprietary. downside: confuses
netadmins, fails-open on
misconfiguration (if you don't add
XAuth). And the configuration is a
tangled mess.
I don't think you have to configure XAuth in their VPN dialer at all.
It pops up a box if asked. That's it.
I don't know racoon well, but it's more likely to support Certificate
Authentication and PSK, less likely to support Mutual Group
Authentication.
There is also MTU fun. Two IOS devices supposedly will to PMTU-D on
various kinds of tunnels including gre and ipsec. I'm not sure PIXen
or the Windows/Mac VPNClient _ever_ do PMTU-D---in some packet dumps
they seem to punt by quietly defaulting to a small MTU like 1200 -
1300. and I think BSD/Linux doesn't do PMTU-D either but might
confuse you by having a larger default.
source: http://mail-index.netbsd.org/current-users/2009/01/27/msg007643.html
No comments:
Post a Comment